Table of Contents
Advertisement
2.3 Remove the Base Assembly
for VESA Mounting
Before you start disassembling the monitor
base, please follow the instructions below
to avoid any possible damage or injury.
1. Extend the monitor base to its
maximum height.
2. Place the monitor face down on a
smooth surface. Pay attention not to
scratch or damage the screen. Then lift
the monitor stand.
3. While keeping the release button
pressed, tilt the base and slide it out.
Note
This monitor accepts a 100mm x 100mm
VESA-Compliant mounting interface.
VESA Mounting Screw M4. Always contact
manufacturer for wall-mount installation.
* Display design may differ from those
illustrated.
Warning
•
To avoid potential screen damage,
such as panel peeling, ensure that the
monitor does not tilt downward by
more than -5 degrees.
•
Do not press the screen while
adjusting the angle of the monitor.
Grasp only the bezel.
11
2
1
100mm
0°
-5°
90°
Advertisement
Table of Contents
