Husqvarna CT 36A/A-V Operator's Manual page 10

CAUTION:
blade pitch cable is in the groove of the
pulley and not on the outer side of the
pulley.
5. Put the handle in the handle holder and install the 2
bolts (C) and the 2 nuts (D). Tighten the nuts to 24
Nm/18 lb-ft.
D
6. Loosen the blade pitch cable:
F
a) For products with blade pitch knob (F), turn the
blade pitch knob fully counterclockwise.
b) For products with Pro-Shift
®
Pro-Shift lever fully forward.
7. Put the blade pitch cable through the blade pitch
fork.
8. Attach the cable nut to the blade pitch cable.
9. Adjust the cable nut. The adjustment is correct when
the blade pitch cable is straight when the blades
have no pitch.
10
Make sure that the
C
G
®
lever (G), push the
To install the throttle cable
1. Move the throttle control to the idle speed position.
2. Put the throttle cable through the clamp on the recoil
cover of the engine.
3. Put the bend of the throttle cable in the hole in the
throttle plate (A).
A
Note:
The air filter assembly can be removed to
get easier access.
B
1452 - 003 - 30.01.2023