Table of Contents
Advertisement
Chapter 3
S
1
T
ECTION
ROUBLESHOOTING
The following chart provides common problems and possible solutions.
There is a lot of static when calls hand-off
to the repeater.
and/or
The LED on the repeater won't stop
flashing.
Calls won't hand-off to the repeater.
I used to be able to connect to the base, but
now I can't.
I can't register a repeater to the base, and
the repeater is connected through another
repeater.
I can't register a repeater to the base, and
the repeater is connected directly to the
base.
___________________________________________________________________________________
DTL-RPT-2 Cordless DECT Repeater Guide
Troubleshooting and Maintenance
C
HART
Problem
Try
Moving the repeater closer to the base.
Checking for interference from electronic
devices.
Making sure the repeater is not too close to
metal objects or thick walls.
Making sure the repeater is inside the base's
good signal range.
Making sure there is at least 35 feet between
repeaters.
Resetting the repeater and registering it to the
base again.
Making sure the repeater is powered on.
Resetting the repeater and registering it to the
base again.
Make sure there are not already six repeaters
registered to the base.
Make sure there are not already two repeaters
connected to the first repeater.
Re-register the problem repeater to the base.
Re-register both repeaters to the base.
Make sure there are not already six repeaters
registered to the base.
Unplug the problem repeater for about 10
seconds, and then try again.
3 - 1
Advertisement
Table of Contents
