Installing The Repeater - NEC Dterm DTL-RPT-2 Manual

Issue 1.0
___________________________________________________________________________________
S 8 I
ECTION NSTALLING THE
1.
2.
3.
4.
5.
___________________________________________________________________________________
2 - 12
Figure 2-10 Correct Repeater Installation
correctly installed.
Figure 2-10 Correct Repeater Installation
R
EPEATER
Be sure the wall material can hold the weight of the repeater. Never
install a repeater in damaged or decaying wall material.
Hold the repeater in its final location, and mark the location of one of the two
wall slots along the top of the repeater.
From that mark, measure down approximately 1-1/2 inches (about 38mm), and
mark the screw location.
Measure over 2-3/8th inches (about 60mm) and mark the second screw
location.
At the screw location, use a 3/16ths drill bit to make a pilot hole approximately
one inch deep.
Place the wall anchor into the pilot hole and tap it gently with a hammer until the
anchor is flush with the wall.
term
D Cordless DECT
illustrates repeaters that have been
Getting to Know Your Repeater