4
Operation
4.8
Stopping the machine and putting it into operation again
4.8.1
Putting the machine into operation after a synchronous stop
OPERATION
METHOD
Stop the machine
During production, press key (1) or one of
for a short period
the displayed screens or at the back of the
(synchronous stop)
electric cabinet.
If necessary, stop the vacuum pump using
S−4a−3 and/or open the draw−off belts
using S−4a−2.
Putting the
Press (2) or S−14. After all other stops,
machine into
see below.
operation after a
synchronous stop
4.8.2
Putting the machine into operation after any other stop
OPERATION
METHOD
Remedy any
Remedy failures and reports in S−15 and
failures
S−16 or field (4), in accordance with
Section 5.
If necessary,
Select the desired functions in S−3.
produce and check
Press S−11 or S−12.
some empty bags
Check seams, bag length, cut−off position,
etc. In case of any problems, see Section
5.
Produce and check
Press key (5) or key (2) in S−13 or S−14.
some filled bags
Check for correct filling, seams, etc. In
case of problems, see Section 5.
Put the machine
Select the desired functions in S−3.
into operation
Press (5) or S−14.
Check bags.
PAGE 52
REMARKS
The cycle will be completed
and the machine will remain
waiting in the starting position.
The vacuum pump will stop
automatically after time (level
3) S−4a−7a−3−7.
A synchronous stop is only
possible by pressing one of
the stop buttons (1).
REMARKS
E.g. pull out the
'EMERGENCY OFF' impact
button (3).
Precaution before starting
production.
Bosch Verpackungstechnik
T4.8−E33
−
en