Re-Commissioning After A Standstill; Operation; Information On Operation; Wear - Bosch rexroth BS 2/C Series Assembly Instructions Manual

8.3 Re-commissioning after a standstill

Follow the steps outlined for the initial commissioning.

9 Operation

Hot electric motor surfaces during operation!

Risk of burns from touching hot surfaces above 65 °C

Install appropriate guards.

Let the unit cool down for at least 30 minutes before performing maintenance
and/or repair work.
Malfunction of the belt section in reversible operation

Operating the belt section exclusively opposite the preferred direction
(workpiece pallet moves to the drive head) leads to failure of the chain
tensioner or even to crash. There is a risk of damage to property.

Comply with the preferred direction (workpiece pallet moves to drive head).

If the overrun mode is used exclusively, change the conveying direction for one
chain cycle every 1000 h to ensure the function of the chain tensioner.
Wear due to congestion on the connection belt roller

Congestion on the connection belt roller (BS 2/C-H, ...R-H, ...R-V) leads to
increased wear at the workpiece pallet. There is a risk of damage to property.

Avoid congestion on the connection belt roller.

9.1 Information on operation

9.1.1

Wear

• Individual components are subject to unavoidable wear by their very nature.
Constructive measures and the selection of materials help ensure functional
safety over the full service life. However, wear is also dependent on
the operating, maintenance and ambient conditions at the place of use
(resistance, contamination).
• Overloading the conveyor sections can cause the conveyor medium to malfunction
and lead to the premature breakdown of motors and gears.
• If pneumatically activated components are overloaded, it is not possible to
guarantee their function.
9.1.2

Measures to reduce wear

The following obvious measures will reduce wear:
• Switch off the conveyor section during line downtime, e.g. during breaks,
at night and on weekends.
• Do not select a higher speed for the conveyor section than that required for the
corresponding function.
CAUTION
NOTICE
3 842 563 834/2022-08, MIT: BS 2/C-..., BS 2/R-..., Bosch Rexroth AG
Operation 39/84