Re-Commissioning After A Standstill Period; Adjusting Lifting Speed - Bosch Rexroth HQ 2/C-H Assembly Instructions Manual

Please note:
• Mount the corresponding
WT workpiece pallet before
confi guring the lifting
speed (operating load).
• Try to confi gure the HQ to
lift evenly and smoothly.

Throttle the supply
air evenly using both
throttles to adjust the
lifting speed.
• Rotate in the "+" direction
The movement is slower.
• Rotate in the "–" direction
The movement is faster.

8.3 Re-commissioning after a standstill period

Follow the steps outlined for initial commissioning.

8.4 Adjusting lifting speed

Sudden movements
Risk of serious injury or death.

Final commissioning may only be performed with protective devices in place.
These must be provided and installed by the customer.
X
-
+
Fig. 23: Adjusting lifting speed (HQ 2/C-H shown)
3 842 358 792/2016-12, Material and information fl ow technology: HQ 2/C-H, HQ 4, Bosch Rexroth AG
Commissioning
WARNING
39/64
Y
551 261-23