Table of Contents
Advertisement
2U4N Configuration Equipment Installation
2U4N configuration installation guidelines
Installation in cabinets with single-phase power distribution
VxRack Node Hardware Installation Guide
32
Assuming installation is into an empty rack, always begin component installation at the
bottom of the cabinet and install upward. Install components at the lowest available
space for that component type.
The quantities of components that can be installed in a cabinet are dependant on the
type of power distribution units installed in the cabinet.
The following sections provide the component stack up as applicable to the type of
power distribution for your installation:
In cabinets with single-phase power distribution, refer to
l
with single-phase power distribution
In cabinets with 3-phase delta or 3-phase wye power distribution, refer to
l
Installation in cabinets with 3-phase delta or 3-phase wye power distribution
page 33
If you are installing the system in a cabinet with single-phase power distribution, the
maximum stack up will be as follows:
Component
Description
Function
Data Server
Quanta 2U4N Server
Management Server
Kylin 1U Server
Management Switch
Arista 7010T-48
Data Switch (A and B)
Arista 7050-128
Data Switch (C and D)
Arista 7050-64
on page 32
Table 6 Maximum stack up in cabinets with single-phase power
distribution
Quantity
14
1
2
2
2
Installation in cabinets
on
Cabinet U Space
2 - 17, 26 - 31, and 34 - 39
18
19 and 21
22 - 25
32 - 33
Advertisement
Table of Contents
