Table of Contents
Advertisement
Configure the data switch
This procedure is used to configure the data switch.
Procedure
1. Copy the configuration filename from the USB flash drive using the following
command:
enable
2. Then, copy
usb1:<configuration file>startup-config
Example:
localhost> enable
l
locathot> copy usbl
l
3. Type
to activate the new configuration.
reload
This causes the switch to reboot.
4. When prompted, System configuration has been modified. Save?,
type
.
no
5. When prompted, Proceed with reload?, press enter.
6. The switch reboots and you will see a set of reboot messages. It takes about
one minute for the switch to reboot. It returns to the login: prompt if
successful.
7. Check the group of four LEDs on the front of the switch. All four of the LEDS
should be solid green.
Note
Now we will configure a Mgmt IP for each switch.
8. Login to the switch again , this time the password is Scaleio123
9. Type
and click enter.
enable
10. Type
configure
11. Type
interface management 0
virtual interface which accesses management port 1 on the currently active
supervisor.
12. Type
ip address
address for access to the active management port.
Example, this command assigns the IP address 10.0.2.5 to management port 0:
switch(config-if-Ma0)#ip address 10.0.2.5/24
l
13. Type
twice at the interface configuration and global configuration prompts
end
to return to Privileged EXEC mode.
14. Type
(or copy running-config startup-config) to save the new
write
configuration to the startup-config file.
15. Disconnect the service laptop from the console port IOIO.
.
terminal (or
) to enter global configuration mode.
config
to enter interface configuration mode for the
, followed by the desired address, to assign a virtual IP
2U4N Configuration Equipment Installation
.
Configure the data switch
47
Advertisement
Table of Contents
