Mono Display; Display Parameter; Auto Mode; Manual Mode - Honeywell TR50 User Manual

3.1.4 Mono Display

The Mono segment display on the TR50 IAQ Sensor is used to show the air quality
sensor parameter values.

3.2 Display Parameter

The Display Parameter of TR50 IAQ Sensor have 2 different modes
•
•

3.2.1 Auto Mode

After the installation and configuration, the display will show the parameter values
per cycle time. The default time for the cycle to change the parameter is 5 seconds.
If the SKU don't have PM2.5 and TVOC in the device, or installer
configure to hide the parameters, the display will jump to next parameters.
When the TR50 device is powered on, the LCD display brightness will be in normal
mode and the LCD display will be changed to dim/dark mode in seconds that is
pre-setting.

3.2.2 Manual Mode

Under the manual mode the installer will configure the required parameters. The
cycle time to display the parameters can be set manually from the range of
3-10 seconds or swipe the touch button to change the parameters.
When the TR50 device is powered on, the LCD display brightness will be in normal
mode and the LCD display will be changed to dim/dark mode in seconds that is
pre-setting.
TR50 - User Guide
Auto Mode
Manual Mode
14