Chapter 4 - Configuration; Topologies Used To Connect Tr50 Iaq Sensor; Dip Switch Configuration - Honeywell TR50 User Manual

CHAPTER CHAPTER
4 4
CONFIGURATION

4.1 Topologies used to connect TR50 IAQ Sensor

To configure the TR50 IAQ Sensor, the device must be connected to plant or unitary
controller. Before configuring the device, complete the dip switch configuration
and connect the device to plant controller or unitary controller through RS-485
cables and connect your supervisor's workstation (Laptop or PC) to the same
network. For more details refer
Engineering Guide, Smart Sensor configuration section.

4.2 Dip Switch Configuration

The Dip switch is used to change the communication protocols as per the selected
networks.
The below figure describes the different switch how to communicate the networks:
TR50 - User Guide
System Architecture
Slide Switch
Protocols
on page 3 and Niagara/CPO
Dip Switch
MAC Address
15