Frigidaire GCWG2438AW Use & Care Manual page 44

44
Before You Call
Self-clean Problems
Problem
Self clean does not work .
Oven racks discolored or
do not slide easily .
Soil not completely re-
moved after self clean .
Other Problems
Problem
Appliance is not level .
Cannot move appliance
easily . Appliance must be
accessible for service .
Oven light does not work .
cause / Solution
Oven control not set properly . See "Self Clean" on page on 33 .
Oven racks left in oven cavity during self clean . Remove oven racks from
oven cavity before starting a self-clean cycle . Clean by using a mild abrasive
cleaner following manufacturer's instructions . Rinse with clean water, dry,
and replace in oven .
Self clean was interrupted . Review instructions on "Self Clean" on page on
33 . Excessive spills on oven bottom . Remove excessive spills before starting
self clean .
Failure to clean soil from the oven frame, the door liner outside the oven
door gasket, and the small area at the front center of the oven bottom .
These areas are not in the self-cleaning area, but get hot enough to burn on
residue . Clean these areas before starting the self-cleaning cycle . Burned-on
residue can be cleaned with a stiff nylon brush and water or a nylon scrub-
ber . Be careful not to damage the oven gasket .
cause / Solution
Poor installation . Place the oven rack in the center of the oven . Place a level
on the oven rack . Adjust the leveling legs at the base of the appliance until
the rack is level .
Kitchen cabinet alignment may make range appear not level . Be sure cabi-
nets are square and have sufficient room for appliance clearance .
Cabinets not square or are built in too tightly . Contact the builder or install-
er to make the appliance accessible .
Be sure the oven light is secure in the socket . See "Self Clean" on page on
33 .