Table of Contents
Advertisement
INSTALLATION INSTRUCTIONS
Installation and wiring should be done
by authorized person. (Wiring is required
to follow the local wiring regulations.)
Otherwise, a fire may be caused.
Product must be installed tightly.
Otherwise, product may fall
off to cause personal injury.
Components must be installed
tightly.
Otherwise, components may fall
off to cause personal injury.
INSTALLATION REQUESTS
Do not install the product in
places with high temperature.
Otherwise, it may
cause the product
deformation or the
motor life shorten.
Do not install product on a
slanting ceiling.
Otherwise, it may cause
the product abnormal.
Use a wall switch (supply on market)
as the power switch for product
(Turning ON/OFF to control the product).
Install the product over 1.5 m apart from the fire annunciator. Otherwise it may
cause false action of the fire annunciator. For detail, please confirm the fire
annunciator instructions.
WARNING
CAUTION
Do not install the product outside the
window or wall.
Do not install the product where is
exposed to oil mist, such as kitchen etc.
Do not reconstruct this product.
Ambient
temperature
above 40 °C
Within
50 cm
Please select 60227 IEC 53 (RVV)
ordinary polyvinyl chloride sheathed
cord. Nominal cross-sectional area
of conductors is 3×0.75 mm
Otherwise, it may be on fire.
Otherwise, product may fall off to
cause personal injury.
Otherwise, short circuit
may result in fire.
Otherwise, it may cause damage
to the product.
Do not install product to bathroom etc.
where is exposed to humidity.
Otherwise, it may cause the product
abnormal.
Install the product at the position as
the figure show below.
Above 150 mm
Otherwise, it may cause the wall dirty.
Suggest to install the product over
1.5 m apart from the vent.
Otherwise, it may affect the
performance of the product.
.
2
Above 150 mm
3
Advertisement
Table of Contents
