Table of Contents
Advertisement
Removing a hard disk drive from a hard disk drive carrier
1. Remove the four screws from the slide rails on the hard disk drive carrier.
2. Lift the hard disk drive out of the hard disk drive carrier.
Remove the screws from the slide rails on the hard disk drive carrier and separate the hard disk drive from the carrier.
Figure 10. Removing and installing a hard drive into a 2.5-inch hard disk drive carrier
1. screws (4)
2. hard disk drive
3. hard disk drive carrier
Installing a hard disk drive into a hard disk drive carrier
1. Insert the hard disk drive into the hard disk drive carrier with the connector end of the hard disk drive at the back.
2. Align the screw holes on the hard disk drive with the back set of holes on the hard disk drive carrier.
When aligned correctly, the back of the hard disk drive is flush with the back of the hard disk drive carrier.
3. Install and tighten the four screws to secure the hard disk drive to the hard disk drive carrier.
Enclosure Management Module
An enclosure with redundant enclosure management contains two enclosure management modules (EMM). You can cable your enclosure
either in a single port, redundant mode or in a multi-mode configuration. If only one EMM is installed in your enclosure, it must be installed
in EMM 0. You must install the EMM blank in EMM 1.
NOTE:
EMMs can be removed and installed without turning off the enclosure.
CAUTION:
It is recommended that you do not remove an EMM while data is being transferred.
CAUTION:
Replacing or installing an EMM that is connected to a host server causes it to end communication with the
enclosure and requires a restart of the host server.
Removing an EMM blank
CAUTION:
To maintain proper system cooling, make sure you install an EMM blank in the empty slot.
1. Remove EMM 0. See
Removing an EMM
2. To remove the EMM blank, press down on the release latch and pull the blank away from the enclosure.
14
Installing enclosure components
blank.
Advertisement
Table of Contents
Troubleshooting
