Table of Contents
Advertisement
ATTACHMENTS AND OPTIONS
HANDLING MACHINES EQUIPPED WITH KOMTRAX
KOMTRAX is a machine management system that uses wireless communications.
A contract with your Komatsu distributor is necessary before the KOMTRAX system can be used. Any customers
desiring to use the KOMTRAX system should consult their Komatsu distributor.
The KOMTRAX equipment is a wireless device using radio waves, so it is necessary to obtain authorization and
conform to the laws of the country or territory where the machine equipped with KOMTRAX is being used. Always
contact your Komatsu distributor before selling or exporting any machine equipped with KOMTRAX.
When selling or exporting the machine or at other times when your Komatsu distributor considers it necessary,
it may be necessary for your Komatsu distributor to remove the KOMTRAX equipment or to carry out action to
stop communications.
If you do not obey the above precautions, neither Komatsu nor your Komatsu distributor can take any
responsibility for any problem that is caused or for any loss that results.
BASIC PRECAUTIONS
Never disassemble, repair, modify, or move the communications terminal, antenna, or cables. This may cause failure or fire
on the KOMTRAX equipment or the machine itself. (Your Komatsu distributor will carry out removal and installation of
KOMTRAX.)
Do not allow cables or cords to become caught; do not damage or pull cables or cords by force. Short circuits or disconnected
wires may cause failure or fire on the KOMTRAX equipment or the machine itself.
For anyone wearing a pacemaker, make sure that the communications antenna is at least 22 cm (8.7 in) from the pacemaker.
The radio waves may have an adverse effect on the operation of the pacemaker.
Near the blasting jobsite, there may be a danger of unexpected explosion due to use of interactive wireless communication
device of KOMTRAX and resulting serious personal injury. Make sure to operate the machine away from the blasting jobsite.
If you have to operate the machine within 12 m (39 ft 4 in) from the blasting jobsite or the remote blasting device, ask your
Komatsu distributor to disconnect power source cable of KOMTRAX in advance.
If there are any restriction or law of the territory or country where the machine equipped with this device is used, such
restriction or law has a priority than this warning.
KOMTRAX specifications are as follows.
Rated horsepower: 5 - 10 W
Operating frequency: 148 - 150 MHz
NOTICE
Even when the key in the starting switch of the KOMTRAX system is at the OFF position, a small amount of electric power is
consumed. When putting the machine into long-term storage, take the action given in "LONG TERM STORAGE (PAGE 3-144)".
Please contact your Komatsu distributor before installing a top guard or other attachment that covers the cab roof.
Be careful not to get water on the communications terminal or wiring.
REMARK
The KOMTRAX system uses wireless communications, so it cannot be used inside tunnels, underground, inside
buildings, or in mountain areas where radio waves cannot be received. Even when the machine is outside, it
cannot be used in areas where the radio signal is weak or in areas outside the wireless communication service
area.
There is absolutely no need to inspect or operate the KOMTRAX communications terminal, but if any abnormality
is found, please consult your Komatsu distributor.
HANDLING MACHINES EQUIPPED WITH KOMTRAX
WARNING
6 - 23
Advertisement
Chapters
Table of Contents
