Power Turn-On Sequence; Usb Cable; About Led - Panasonic Camescope KV-S1020C Operating Instructions Manual

Setting up the Scanner

Power turn-on sequence

1
Turn on the power of the scanner.
• Connect the power cord to the AC adaptor.
• Connect the AC adaptor to the scanner.
• Plug into an AC outlet.
• Push the power switch.
• The LED (Green) will blink for about 30
seconds and then it will become steady.
Note:
• Install the software first.

About LED

The status of the scanner can be established by the condition of the two LED indicators shown in the table below:
LED (Green)
ON
Blink (Slow)
ON
Blink (Slow)
ON
Blink (Fast)
*1
The scanning lamp(s) periodically lights up in sleep mode. This is not an unusual event.
For details on sleep mode, refer to the User Utility Reference Manual.
*2
It will take about 30 seconds to initialize the scanner.
12
Power switch (
Power cord
LED (Green)
LED (Red)
LED (Red)
OFF Ready
OFF Sleep
Blink (Slow) Warning
Blink (Slow) Warning/Sleep
ON Error
OFF Warming up
)
AC adaptor
Ready
Error
Start / Stop
Status
*1
*2

USB cable