Yamaha PW SYSTEM Manual page 57

Lock-release ring Lock-release ring
PASC10
NOTICE
• Do not connect the charging plug of the Battery
Charger with the charging connector of the Battery
Pack in a wet state.
Otherwise, the Battery Charger and Battery Pack
may malfunction.
• Be sure to connect the charging plug only after the
charging connector on the Battery Pack is com-
pletely dry.
Otherwise, the Battery Charger and Battery Pack
may malfunction.
• Do not apply excessive force to the charging plug
or pull on the cord with the charging plug connect-
ed to the Battery Pack.
Otherwise, the charging plug or connector may be
damaged.
• Do not pedal while the charging plug is connected.
3. See "Reading the charging status for Battery Pack",
and check that the Battery Charger is charging the Bat-
tery Pack.
4. The battery capacity indicator lamps will light up one by
one until all four are on. Then, when charging is com-
plete, all of the lamps will go off.
5. Confirm that charging is complete, and then disconnect
the charging plug from the Battery Pack.
How to disconnect the charging plug of Battery Charger
type PASC10 (see the left figure)
Grasp the lock-release ring.
Pull it out straight.
6. Place the cap of charging inlet on the Battery Pack's
charging connector.
WARNING
Never handle the power plug, charging plug or touch
the Battery Charger contacts with wet hands. This
could result in electric shock.
TIP
• Charging will start automatically.
• If the Display Unit is turned on while the Battery Pack is
charging, all normal displays will be shown, including
the battery capacity indicator, but the assist system will
not function.
• When the Battery Pack is connected to the Battery
Charger, the battery capacity indicator lamp will flash at
approximately 0.2 second intervals to indicate that the
Battery Pack is being prepared to be charged. Leave it
alone and charging will start normally.
• If you charge the Battery Pack with the Battery Pack in-
stalled in the bicycle, the headlight might go off.
57