Panasonic WJ-MPU955A User Manual page 151

R S 4 8 5 D A T A P O R T
F i e l d D a t a
Data Description: Specifies serial communication packet size.
Validation: 5 = 5bits, 6 = 6bits, 7 = 7bits, 8 = 8bits
Default Setting: 8
Parity Description: Specifies serial communication parity bits.
Validation: 0 = None, 1 = Odd, 2 = Even
Default Setting: 0
Stop Bit Description: Specifies serial communication stop bits.
Validation: 1 = One bit, 2 = Two bits
Default Setting: 1
Mode Description: Specifies serial communication packet mode
Validation: 0 = Fixed size - When the receiving serial data size reaches the size in "Data size" ,
the encoder will send a packet to the network.
1 = Timer - When it has past a longer waiting time for receiving data than the entered time in
"Timer", the encoder will send a packet to the network.
Default Setting: 0
Data Size Description: Specifies maximum data size in a single packet while transmitting data. This
setting is only effective when Mode is set to 0.
Validation: 1 - 1024 byte(s)
Default Setting: 200
Timer Description: Specifies maximum waiting time while transmitting data. This setting is only
effective when Mode is set to 1.
Validation: 10 - 1000 ms (in 10ms intervals)
Default Setting: 100
Destination Setup Description: Specifies a destination for serial to IP communication.
Validation: 0 = Use default destination IP address - Serial data will be sent to the IP address
contained in the received packet at the encoder side.
1 = Use following configuration, Destination IP address and Destination Port No.
Default Setting: 0
Destination IP Description: Specifies a destination IP address for serial to LAN communication. This setting
is only effective when Destination Setup is set to 1.
Address
Validation: Dotted decimal format
Default Setting: (None)
Destination Port Description: Specifies a send IP port number for serial to LAN communication. This setting is
only effective when Destination Setup is set to 1.
No.
Validation: hexadecimal numeral, 0000 -FFFF
Default Setting: (None)
Receiving Port Description: Specifies a receiving IP port number for serial to LAN communication.
No.
Validation: hexadecimal numeral, 0000 -FFFF
Default Setting: (None)
Comment Description: A string to put comment notes.
Validation: Within 16 characters.
Default Setting: (None)
Appendix A
147