Panasonic WJ-MPU955A User Manual page 63

F i e l d D a t a
Type Choose the type of action to perform when the alarm is triggered. Click on the first
ID Identifies the ID number of the camera, tour sequence, or group sequence depending on
CPre CPreset. Number identifying a preset position of the camera specified. 0 to 255 (0 =
Aux Choose if an auxiliary function will take place. An auxiliary function requires
Dwell Amount of time that a monitor maintains a view. Up to 59:59 (hr:min)
Text Practical name given to an action, or in the case of the action type of Text Only,
Assign an Available Target
The Target tab from the Alarms window allows an administrator to assign an existing
target ID to a specific alarm. The existing target IDs appear under the Available section
of this window.
The Monitors section of this window shows the administrator which monitors are part of
the highlighted target ID; and the display mode section shows the mode for the target.
Monitors can also be viewed by area\local number.
Configuration
A l a r m s – A c t i o n s
blank box under this column, and select Cam Spot (camera spot), Tour Seq (tour
sequence), Grp Seq (group sequence), or Text Only.
what was selected as the action type. Choose the ID number off of the list that appears
at the right of the Alarms window when on this tab.
no preset). This setting is only available and necessary when Cam Spot is the selected
action type.
additional hardware at the chosen camera – such as a camera receiver switch. If
unavailable or not desired, choose None. If available and desired, choose Aux1, Aux2,
or Both as the function to perform during that action. This setting is only available and
necessary when Cam Spot is the selected action type.
specifies the text that will be displayed.
59