Installing The Combiner Cabinet; Installing The Combiner Cabinet (Concrete Floor) - Huawei PDU8000 Quick Manual

Dc combiner cabinet

Hide thumbs Also See for PDU8000:

Table of Contents

PDU8000 DC Combiner Cabinet

Quick Guide

Procedure

Step 1 Mark the positions for installing expansion bolts based on the marking-off

template.

Figure 5-1 Marking-off template (unit: mm)

Step 2 Drill holes at the marked positions using a hammer drill and install expansion

bolts.

Issue 02 (2022-08-10)

Installing the Combiner Cabinet

Use a hammer drill to drill holes at the four marked positions. Ensure that the

depth of each hole ranges from 52 mm to 60 mm and all holes are of the

same depth. Use a vacuum cleaner to clean up dust inside and outside the

drilled holes.

Slightly tighten expansion bolts to prevent the expansion sleeves from

fluttering. Then, hammer the expansion bolts into the holes vertically until the

flat washers are flush with the floor.

Partially tighten the expansion bolts clockwise.

Loosen the bolts counterclockwise and remove the flat washers and spring

washers.

5 Installing the Combiner Cabinet

Table of Contents