Installation - Toshiba GR-B31MU Owner's Manual

安裝
安裝
將雪櫃安裝在堅固水平的地面上。轉動調整腿使雪櫃保持
水平。
- 右側調整腿可以上下調節。
- 順時針轉動調整腿可抬起雪櫃
兩側，逆時針轉動則可降低。
雪櫃的安裝位置。
不宜把雪櫃置於潮濕的地方，例如廚房的水槽附近。否則會導
致雪櫃銹蝕或漏電。如直接放在地面上，則應在下面墊上木板
等，否則亦易損壞機器。
遠離陽光直射處及煤氣爐或其他熱源。
如果雪櫃受陽光直射，或放置在其他熱
源附近，則會導致製冷效果下跌，甚至
產生故障。
雪櫃四周要留有空隙。
選擇通風良好的地方。在雪櫃頂部、
後部、左右側分別留出至少 30 cm
（12 英吋）、10 cm（4 英吋）、
5 cm（2 英吋）的空間以保持適
當的空氣循環。
初次開啟雪櫃門時，可能會有塑料的氣味。這並非異常情況。
不使用時關閉雪櫃電源。
準備離開較長時間時，如果關閉雪櫃電源，請取出所有食品並
徹底清潔內部。從電源插座拔下電源線插頭，並使雪櫃門保持
開啟。
移動或安裝前請小心。
移動或安裝時，後側 PCB 箱可能受到影響，
從而損壞雪櫃。
資訊
● 壓縮機放熱
在正常情況下，雪櫃的壓縮機要向外放出熱量。請注意這並非
故障。
● 雪櫃外壁上的熱量
雪櫃的冷凝器裝於雪櫃的外壁內，並通過雪櫃外壁將熱量散到
室內。在正常工作時，雪櫃外壁的溫度會很高，這並非雪櫃發
生故障。
● 雪櫃的運轉
初次接通電源或環境溫度升高時，可能會發生雪櫃表面發熱或
壓縮機發出噪音的情況。
當雪櫃進入穩定狀態時，將正常執行。

INSTALLATION

Installation
Install your refrigerator on a strong and level oor. Turn the
adjustable leg and stabilize the refrigerator horizontally.
調整腿
Adjustable Leg
下 上
Down Up
Installation position for refrigerator.
Avoid any humid or wet place, for example, the neighborhood
of a kitchen sink. Such a place could cause corrosion or
electric leakage in the refrigerator. If installed directly on the
ground, your refrigerator will be liable to damage. Place a
board under the machine in such a case.
Keep the refrigerator away from the sunlight, a gas range
or heater.
Placed in the sunlight or near a heat emitting object, the
refrigerator will have its cooling e ect reduced and a failure
might be occured.
Leave space around the refrigerator.
至少 30cm
Select a well-ventilated place. Provide at least 30 cm(12 inches)
at least 30 cm
at top,10 cm(4 inches) at rear side and 5 cm(2 inches) on the
left and right of the refrigerator for proper air circulation.
至少 10cm
at least 10 cm
至少 5cm
at least 5 cm
When you open the door of the refrigerator, there may be
a smell of plastics. This signi es nothing unusual.
Switching o your refrigerator when not using.
If you switch your refrigerator o when you are going away
for an extended period, remove all food, clean the interior
thoroughly. Remove the power cord plug from the power
socket and leave all doors open.
Be careful before moving or installation.
If you have moving or installation, maybe impact
around PCB Box at rear side which have a damage
to refrigerator.
PCB 箱
PCB Box
INFORMATION
•
Heat Generation by the Compressor
The refrigerator compressor will generate heat during normal
operation. Note that this is not a malfunction.
•
Heat on Refrigerator Walls
The condenser is built on the outer shell and radiates heat
into the room air. The temperature of the outer shell may
reach high temperature during normal refrigerator operation.
This is not a malfunction.
•
Refrigerator Operation
When the power is rst turned on or ambient temperature
becomes high, it may happen that the refrigerator surface
getting warm or noise from the compressor.
When the refrigerator enters stable state, it will run normally.
-7-
- Adjustable leg right side can be adjust up and
down.
-
Turn adjustable leg clockwise to raise each side
of the refrigerator, or turn counter clockwise
lower it.