Table of Contents
Advertisement
PV+ESS+Charger Solution
User Manual
4.5.5 Starting and Stopping Charging Using an RFID Card
Precautions
●
●
Starting Charging
Place the ring pattern on the RFID card in the swiping area. If the indicator blinks
blue fast three times, the card is swiped successfully.
●
●
Figure 4-14 Charging by card swiping
Stopping Charging
After the vehicle is fully charged, the charger automatically stops charging. In this
case, the indicator is steady blue. You can also swipe the RFID card in the swiping
area to stop charging.
4.5.6 Charger Settings
Plant Management
Owners can log in to the FusionSolar app to bind or unbind a charger.
1.
2.
Issue 02 (2023-01-13)
Before charging, make sure your RFID card has been added to the system. For
details, see
Adding an RFID
Before charging, you need to completely insert the charging connector into
the charger and vehicle. If the indicator on the charger turns blue on and off
cyclically (on for 4s and off for 1s), the charger is successfully connected to
the vehicle.
If scheduled charging is not set, wait until the indicator on the charger turns
blue on and off cyclically (on for 0.5s and off for 0.5s), indicating the charging
state.
If scheduled charging is set, the charger enters the waiting state and the
indicator turns blue on and off cyclically (pulsating blue for 4s and off for 1s).
The charging automatically starts at the scheduled time. You can also swipe
the card again to start charging immediately.
Choose Me > Plant management and tap the target plant.
Tap Add device, and then tap
Copyright © Huawei Technologies Co., Ltd.
Card.
.
4 System Commissioning
58
Advertisement
Table of Contents
