Advertisement
5. Remove part of the metal belt cover support on top of the mower as shown in the figure
below.
6. Install the pivot bracket using the 3 bolts (3/8 x 1 inch) and 3 locknuts (3/8 inch).
3462-361A
G431999
G432000
Page 5
Cut 25 mm (1 inch) off the metal
belt cover support here.
Mower deck
Align template with mower deck
edge
Metal template
Drill 3 pilot holes (1/8 inch) and 3
diameter holes (13/32 inch)
Template location on the mower
deck
Mower deck
Bolt (3/8 x 1 inch)
Blower assembly pivot
Locknut (3/8 inch)
Drilled holes
Advertisement
