Table of Contents
Advertisement
Wipe protection
You can lock the SmartLine element
sensor controls for 20 seconds in
order to remove soiling, for example.
The sensor control is not locked.
Activating
Touch the sensor control.
The time counts down in the timer
display.
Deactivating
Touch the sensor control until the
timer display goes out.
Demonstration mode
This function enables the SmartLine
element to be demonstrated in
showrooms without heating up.
Activating/deactivating
demonstration mode
Switch the SmartLine element on.
Touch the 0 sensor on any of the
numerical keybanks.
Then touch the 0 and 2 sensors at
the same time for 6 seconds.
In the timer display, flashes
alternately with (demonstration mode
activated) or (demonstration mode
deactivated) for a few seconds.
Additional functions
Displaying the SmartLine
element data
The model designation and software
version of the SmartLine element can
be displayed. To do this there must not
be any pots or pans on the SmartLine
element.
Model designation
Switch the SmartLine element on.
Touch the 0 sensor control on any of
the numerical keybanks.
Then touch the 0 and 4 sensor
controls at the same time.
The timer display shows 2 numbers
flashing alternately:
flashes alternately with = CS 1234
Software version
Switch the SmartLine element on.
Touch the 0 sensor control on any of
the numerical keybanks.
Then touch the 0 and 3 sensor
controls at the same time.
Numbers will appear in the timer
display:
: = software version
33
Advertisement
Table of Contents
