Connect The Connect App; Connecting The Device To The; Energy Manager - Bosch WAV28K43 Instructions For Use And Assembly

de Home Connect
16.3 Connect the device to the
Home Connect app
requirements
¡ The device is connected to the WLAN home
network (Wi-Fi) connected.
¡ The Home Connect app is open
net and you have logged on.
Set the program to position 3.
1.
a The display shows APP.
on Start / reload
2.
a The device connects to the
Home Connect app.
As soon as the device is displayed
3.
in the Home Connect app, follow
the last steps in the Home
Connect app.
a When the display con shows is
the device is connected to the
Home Connect app.
16.4 Connect the device to
the energy manager
If you connect the device to the Smart
Energy system (energy manager), you
optimize the energy consumption.
The device only starts when your in-
house photovoltaic system provides
enough energy or the electricity tariff
is low.
requirements
¡ The Smart Energy System (energy
giemanager) uses the
communication standard of the
EEBus initiative.
¡ In the instruction manual you have
The Smart Energy System (energy
manager) reads how the Smart
Energy System (energy manager)
connects to your device.
48
1.
a The display shows Aut.
2.
a The display shows Closely.
3.
a The device connects to the
a When the display con and
to press.
4th
Activate Flexstart
Activate Flexstart so that your Smart
Energy system (energy manager) can
start your device when your in-house
photovoltaic system provides enough
energy or the electricity tariff is cheap.
Pre-condition: The smart energy
system (energy manager) can only
start your device if the smart energy
system (energy manager) and the
device are connected to one another.
1.
2.
3.
4th
a The display shows and the flex
on Remote start
to press.
Set the program to position 7.
on Start / reload
Smart Energy System (energy
manager).
shows, the device has
successfully connected to the

energy manager.

If the device is to be started by the
Smart Energy System (energy
manager), activate Flexstart.
→
"Activating Flexstart", page 48
Set the desired program.
On - Done in + Press and set the
required time period.
on Start / reload
on Remote start
start is activated. The device waits
for the start via the Smart Energy
system (energy manager).
approx. 3 seconds
to press.
to press.
to press.