Troubleshooting; Transportation, Storage And Disposal - Husqvarna AUTOMOWER 320 NERA Operator's Manual

and a low energy use. All 3 blades and screws must
be replaced at the same time to get a balanced cutting
system.
39.4.1 To replace the blades
1. Set the product to OFF.
2. Put the product with the blade disc up on a clean
and soft surface.

40.1 Troubleshooting

If there is a malfunction, a symbol or a message is shown in Automower
For more information on messages, refer to the full Operator's manual, in the Automower
Husqvarna's web site (www.husqvarna.com). If the same message shows frequently or if you cannot find the cause
for the fault, speak to your local Husqvarna representative.
Damage to the loop wire is usually the result of accidental damage to the wire, for example when you use a shovel
where the loop wire is put. Breaks can also occur when the wire is pulled on too much when you install it. Divide the
loop wire into two sections at the time to find where the damage to the loop wire is. Refer to the full Operator's manual
®
in the Automower Connect app or on Husqvarna's web site (www.husqvarna.com).
40.1.1 LED indicator of the charging station for boundary wire installation
The LED indicator of the charging station is green when
the installation is correct. If the LED indicator of the
charging station is not green, follow the troubleshooting
table below.
LED indicator Cause
Constant green The signals of the charging station are good.
Flashes green The signals of the charging station are good
and
Flashes blue The boundary wire is not connected to the
charging station.
The boundary wire is damaged.
Flashes red Interference in the antenna of the charging
station.
Constant red Error in the circuit board or incorrect power
supply in the charging station.

41 Transportation, storage and disposal

41.1 Transportation
The supplied Li-ion batteries obey the Dangerous Goods
Legislation requirements.
• Obey all applicable national regulations.
• Obey the special requirement on package and
labels for commercial transportations, including by
third parties and forwarding agents.
1910 - 002 - 03.01.2023
40 Troubleshooting
ECO mode is enabled.
3. Rotate the skid plate until the holes align with the
screws for the blade.
4. Remove the 3 screws.
5. Remove the 3 blades and the screw.
6. Attach 3 new blades and screws. Use Husqvarna
original blades.
7. Make sure that the blades can move freely.
®
Connect app and in Automower
®
Speak to your local Husqvarna representative or go to
www.husqvarna.com for more information.
Action
No procedure is necessary.
No procedure is necessary.
Connect the boundary wire to the charging
station.
Replace the damaged section of the boun-
dary wire with new boundary wire.
Speak to your local Husqvarna representa-
tive.
The error must be corrected by an authorized
service technician. Speak to your local Husq-
varna representative.
• For how to remove the battery, refer
to the complete Operator's manual on
www.husqvarna.com.
®
Access.
Connect app or on
Troubleshooting - 103