Husqvarna AUTOMOWER 320 NERA Operator's Manual page 91

48
30. Stakes
31. Loop wire for boundary wire and guide wire
32. Connectors for the loop wire
33. Couplers for the loop wire
52
34. Reference station
35. Husqvarna ® Automower
35.6 Symbols on the product
These symbols can be found on the product. Make sure
that you understand them.
WARNING: Read the opera-
tor instructions before you op-
erate the product.
WARNING: Disable the prod-
uct before maintenance or
before you lift the product.
WARNING: Keep a safe dis-
tance from the product when
it is in operation. Keep your
hands and feet away from the
rotating blades of the product.
WARNING: Do not sit on
the product. Do not put your
hands or feet near or below
the product.
Use a detachable power sup-
ply as specified on the rating
plate adjacent to the symbol.
This product complies with the applicable
EU Directives.
This product complies with the applicable
UK Directives.
It is not permitted to dispose the product
as usual domestic waste. Obey national
regulations and use the local recycling
system.
48
Is a part of the installation kit.
49
Is a part of the installation kit.
50
Is a part of the installation kit.
51
Is a part of the installation kit.
52 ™
Is a part of the EPOS
53 ™
Is a part of the EPOS
1910 - 002 - 03.01.2023
49
50
51
53
® EPOS ™ Plug-in
Plug-in Kit.
Plug-in Kit.
The chassis contains components which
are sensitive to electrostatic discharge
(ESD). The chassis must only be opened
and sealed by an authorized service
technician. The warranty will not be
applicable if the seal is broken.
Do not make modifications on the low-
voltage cable.
Do not use a hedge trimmer or a grass
trimmer near the low-voltage cable.
35.7 Symbols on the battery
WARNING: Lithium-ion batteries can
explode or cause fire if disassembled,
short-circuited or handled roughly. Do not
expose to water, fire or high temperature.
Read the user instructions.
Do not discard the battery into fire and do
not expose the battery to a heat source.
Do not immerse the battery into water.
35.8 General manual instructions
The following system is used in the Operator's Manual
to make it easier to use:
italics is a text that is shown in the
• Text written in
display or is a reference to another section in the
Operator's Manual.
• Text written in bold is one of the buttons on the
product.
Introduction - 91