Husqvarna AUTOMOWER 320 NERA Operator's Manual page 97

®
36.5.3 Automower Connect app
The product can connect to mobile devices that have
®
the Automower Connect app installed. Automower
Connect is a free app for your mobile device. You
can use the extended functions for the product in the
®
Automower Connect app.
Dashboard shows the current operation of the
• The
product. You can select an operating mode for the
product in the dashboard.
• The Map shows the current position of the product
and the set center point for the GeoFence function.
Settings menu you can set the settings for
• In the
the product.
• In the Statistics menu you can see the statistics of
the product.
Messages menu you can find the Fault
• In the
messages and the Information messages of the
product.
Support menu you can find the full operator's
• In the
manual for the product and the
you can get help with troubleshooting.
®
The Automower Connect app has Long-range
cellular connectivity, Wi-Fi connectivity and Short-range
®
Bluetooth connectivity.
36.5.3.1 To install the Automower
1. Download the Automower
mobile device.
2. Sign up for a Husqvarna account in the
®
Automower Connect app.
3. An e-mail is sent to the registered e-mail address.
Follow the instructions in the e-mail in less than 24
hours to validate your account.
4. Log in to your Husqvarna account in the
®
Automower Connect app.
36.5.4 To start the product for the first time
When the product is set to ON for the first time, there
are some basic settings to do before the product can
start to operate.
1910 - 002 - 03.01.2023
®
Help Center where
®
Connect app
®
Connect app on your
1. Push the jog wheel for 3 seconds to set the
product to ON.
Note:
®
The Bluetooth
of the product is enabled for 3 minutes. If the
pairing operation between the product and the
mobile device is not completed correctly, use the
jog wheel to select Bluetooth
2. Enter the factory PIN code.
3. Log on to your Husqvarna account in the
®
Automower Connect app.
®
4. Start Bluetooth on your mobile device.
5. Select My mowers in the Automower
app, and add your product.
6. Follow the instructions in the Automower
app.
36.5.5 To install the charging station
CAUTION:
Do not make new holes in
the charging station plate.
CAUTION:
Do not put your feet on the
baseplate of the charging station.
WARNING:
the low-voltage cable and the power supply
unit are clean and dry before you connect
them.
When connecting the power supply, only use a power
outlet that is connected to an residual-current (RCD)
device.
1. Read and understand the instructions about the
charging station. Refer to
the charging station on page 94 .
2. Put the charging station in the selected area.
Note:
Do not attach the charging station to the
ground with the screws until the guide wire is
To install the guide wire on page
installed. Refer to
99 .
3. Open the hatch on the front of the charging station.
4. Attach the top of the charging station.
pairing operation mode
®
to enable it again.
®
Connect
®
Connect
Make sure that the plugs of
To examine where to put
Installation - 97