Page 2
Installation Loose Parts Use the chart below to verify that all parts have been shipped. Procedure Description Qty. – No parts required Prepare the machine. – No parts required Drill the boom. Bracket Bumper Bolt (5/8 x 5 inches) Nut (5/8 inch) Install the stops.
Page 3
Drilling the Boom Installing the Stops No Parts Required Parts needed for this procedure: Bracket Procedure Bumper 1. Measure and mark the holes shown in Figure 1. Bolt (5/8 x 5 inches) Use the flat edges of the boom for the measurements. Nut (5/8 inch) When all holes are marked, use the bracket Bolt (5/16 x 1 inch)
Page 4
Figure 3 Right side shown 1. Center boom asssemlby 4. nuts (5/16 inch) 2. Assembled bracket and 5. Decal bumper 3. Bolt (5/16 x 1 inch) 3. Install a decal 114-9576 as shown in Figure 3. Adjusting the Booms to Level No Parts Required Procedure 1.