Advertisement
Right side shown
1. Center boom asssemlby
2. Assembled bracket and
bumper
3. Bolt (5/16 x 1 inch)
3. Install a decal 114-9576 as shown in Figure 3.
4
Adjusting the Booms to Level
No Parts Required
Procedure
1. At the operator's position, turn the ignition key to
On to energize the system.
2. Move the booms into position so that they are level
with the ground.
3. Remove the key and exit the operator's position.
4. At the hinge, adjust the position of the bumpers so
the boom can not move past level with the ground.
Take care to make sure the bumper is level.
5. Tighten the bolt and nut to lock the bumpers into the
adjusted position. Torque the fasteners to 135-165
ft-lbs (183-223 N-m).
Note: The bumper may experience some compression
over time. If the booms drop below level, use this
procedure to readjust the bumper position needed.
Figure 3
4. nuts (5/16 inch)
5. Decal
4
Advertisement
