Advertisement
2
Drilling the Boom
No Parts Required
Procedure
1. Measure and mark the holes shown in Figure 1.
Use the flat edges of the boom for the measurements.
When all holes are marked, use the bracket
Note: When all holes are marked the bracket can be
used to verify proper spacing prior to drilling.
1. 2 inches
2. 2.27 inches
3. 0.78 inch
2. Drill the holes where marked. The holes should
0.375 or 3/8 of an inch in diameter.
Figure 1
4. 3.625 inches
5. drill 0.375 (3/8) inch
diameter hole
3
Installing the Stops
Parts needed for this procedure:
2
Bracket
2
Bumper
2
Bolt (5/8 x 5 inches)
2
Nut (5/8 inch)
8
Bolt (5/16 x 1 inch)
8
Nut (5/16 inch)
2
Decal 114-9576
Procedure
1. Assemble the stops as shown Figure 2. Hand tighten
only at this time to allow for later adjustment.
1. Bolt (5/8 x 5 inches)
2. Bracket
3. Nut (5/8 inch)
2. Install the stops to the frame using 4 bolts (5/16 x 1
inch) and nuts (5/16 inch) as shown in (Figure 3).
3
Figure 2
4. Bumper
5. Assembled
Advertisement
