NOTE:
Before working inside your computer, read the safety information that shipped with your computer and follow
the steps in
Before working inside your
working inside your
computer. For more safety best practices, see the Regulatory Compliance home page at
www.dell.com/regulatory_compliance.
Topics:
•
Procedure
•
Post-requisites
Procedure
NOTE:
If we have two 3.5-inch hard drives, then the drive connected to SATA 0 will be the primary drive.
1. Place the hard drive in the hard-drive bracket.
2. Align the screw holes on the hard drive with the screw holes on the hard-drive bracket.
3. Replace the four screws (#6-32xL3.6) that secure the hard-drive bracket to the hard drive.
4. Slide the hard-drive assembly into the slot on the side-chassis until it snaps into place.
5. Connect the data cable (SATA 0) and the power cable to the hard drive.
6. Rotate the side-chassis towards the computer until it snaps into place.
7. Replace the screw (#6-32xL6.35) that secures the hard-drive assembly to the side-chassis.
8. Place the computer in an upright position.
Post-requisites
Replace the
computer
cover.
28
Replacing the 3.5-inch hard drive
Replacing the 3.5-inch hard drive
computer. After working inside your computer, follow the instructions in
17
After