Replacing The Power-Button Module; Procedure; Post-Requisites - Dell D19M Service Manual

NOTE: Before working inside your computer, read the safety information that shipped with your computer and follow
the steps in Before working inside your
working inside your computer. For more safety best practices, see the Regulatory Compliance home page at
www.dell.com/regulatory_compliance.
Topics:
•

Procedure

•

Post-requisites

Procedure
1. Route the power-button board cable through the slot on the front panel.
2. Align and snap the power-button module into the slot on the front panel.
3. Connect the power-button board cable to the system board.
4. Rotate the side-chassis towards the computer until it snaps into place.
Post-requisites
Replace the computer cover.

Replacing the power-button module

computer. After working inside your computer, follow the instructions in
Replacing the power-button module
29
After
47