Toro 119-9604 Installation Instructions

Stake Pocket Adapter Kit
2011 and After Workman
Model No. 119-9604
Loose Parts
Use the chart below to verify that all parts have been shipped.
Description
Receiver assembly
Hex-head bolt (1/4 x 3/4 inch)—2013 models
and older
Locknut (1/4 inch)—2013 models and older
Receiver assembly
Hex-head screw (1/4 x 3/4 inch)—2014
models and newer
Installing the Stake Pocket Adapters (for 2013 Models and
Older)
The bed of the machine has 2 locations for stake pocket adapters on each wall. Each kit contains 2 stake pocket adapters and
the following instructions describe drilling holes only at the locations chosen for the installation of the adapters. If multiple kits
are installed, holes will need to be drilled at those locations as well.
1. Locate the drill marks in the holes around the stake pocket holes on the wall of the bed (Figure 1).
2
1. Possible stake pocket adapter locations
2. Drill a 1/4 inch diameter hole at each drill mark (Figure 1).
© 2014—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
® MD Series Utility Vehicle
Qty.
2
4 Install the stake pocket adapters (2013 models and older).
4
2
Install the stake pocket adapters (2014 models and newer).
4
1
Figure 1
2. Drill marks
Register at www.Toro.com.
Form No. 3366-642 Rev B
Installation Instructions
Use
1
1
G014775
Original Instructions (EN) All Rights Reserved *3366-642* B
Printed in the USA.