Advertisement
Procedure
6
7
8
1
Installing the Lift Brackets
Parts needed for this procedure:
1
Lift bracket (left-hand)
1
Lift bracket (right-hand)
2
Locknut (1/2 inch)
Procedure
1.
Remove the top nut securing the left-hand side
of the rollover protection system (ROPS) to the
machine frame
(Figure
Note:
Retain the bolt and the spring washer
for installation.
Left-hand side shown
2.
Align the left-hand lift bracket to the machine
frame
(Figure
2).
Description
No parts required
No parts required
No parts required
1).
Figure 1
Qty.
–
–
–
1. Bolt (existing)
2. Spring washer (existing)
3.
Secure the existing bolt and spring washer with
a new 1/2 inch locknut, and torque the locknut to
102 to 108 N-m (75 to 80 ft-lb).
Important:
positioned so that the convex side faces the
bolt head as shown in
g024660
4.
Repeat the procedure for the right-hand side of
the machine.
2
Use
Check the operation of the attachment
lift.
Adjust the speed and the tracking.
Install the stop plates.
Figure 2
Left-hand side shown
3. Lift bracket
4. 1/2 inch locknut
Ensure that the spring washer is
Figure
3.
Figure 3
g024661
g023904
Advertisement
