Advertisement
2
Installing the Cables onto
the Cam Brackets
Parts needed for this procedure:
2
Cable
1
Cam bracket (left-hand)
1
Cam bracket (right-hand)
Procedure
1.
Remove the jam nut nearest the visible internal
part of the cable
Left-hand side shown
1. Jam nut
2. Cable
2.
Insert the threaded fitting into the opening of the
cam bracket.
3.
Tighten the jam nut to secure the cable assembly
to the cam bracket.
4.
Repeat the procedure for the cable on the other
side.
(Figure
4).
Figure 4
3. Threaded fitting
4. Cam bracket
3
Installing the Cams
Parts needed for this procedure:
2
Cam
2
Socket-head cap screw
2
Jam nut
2
Flange bushing
2
Spacer (3/8 x 17/32 inch)
2
Bolt (3/8 x 1-1/4 inch)
4
Fender washer (3/8 inch)
2
Locknut (3/8 inch)
Procedure
1.
Install a socket-head cap screw and a jam nut
on each cam
•
For the left-hand cam, install the socket-head
cap screw and the jam nut in the left-hand
hole.
•
For the right-hand cam, install the
socket-head cap screw and the jam nut in
the right-hand hole.
g024655
Important:
depth as each other.
1. Left-hand cam
2. Right-hand cam
2.
Install a flange bushing and a spacer in each
cam
(Figure
3
(Figure
5).
Set the cap screws to the same
Figure 5
3. Jam nut
4. Socket-head cap screw
6).
g024663
Advertisement
