Toro 04022 Operator's Manual page 13

Traction and Reel Drive Engagement
Lever
The traction and reel drive engagement lever (Figure 11)
is located on front right side of control panel. Traction
lever has two positions: Neutral and Forward. Pushing
lever forward engages traction drive.
The reel drive lever has two positions: Engage and
Disengage. Move top of lever to the left to engage reel
or back to neutral to disengage reel.
Service/Parking Brake
The service/parking brake (Figure 11) is located on left
front side of control panel. Pulling the lever back over
center will set the parking brake. Brake must be released
before traction drive is engaged.
On/Off Switch
The on/off switch (Figure 11) is located on top of
control panel. Move switch to On position to start
engine and Off to stop engine.
Hour Meter
The hour meter (Figure 11) located on top of control
panel, indicates the total hours of machine operation.
Operator Presence Control
The optional operator presence control must be engaged
before engaging the traction lever or the engine will stop.
Choke Lever
The choke lever (Figure 12) is located on left front of
engine. Lever has two positions: Run and Choke. Move
the choke lever to the half-open position when starting
a cold engine. After engine starts move lever to Run
position. Move the lever toward the air cleaner housing
for full choke
Figure 12
1. Choke lever 2. Fuel shut-off valve
Fuel Shut-Off Valve
The fuel shut-off valve (Figure 12) is located on left
front of engine. Valve has two positions: Closed and
Open. Move lever to closed position (lever horizontal)
when storing or transporting machine. Open valve (lever
vertical) before starting engine.
Recoil Starter
Pull recoil starter handle (Figure 13) to start engine.
1
1. Recoil starter
Kickstand
The kickstand (Figure 14) is mounted to rear of machine
and is used to raise rear of machine for installation or
removal of transport wheels.
1. Kick stand
13
G009975
Figure 13
Figure 14