Setting The Machine To Match Turf Conditions - Toro 04022 Operator's Manual

Setting the Machine to Match Turf Conditions

Use the following table to set the machine to match turf conditions.
Bedbars: Standard and Optional
Part Number
106-2468-01 Standard
99-3794-03 Aggressive
Bedknives: Standard and Optional
Part Number
93-4262 Microcut
93-4263 Tournament
93-4264 Low Cut
108-4303 Extended Microcut
Rollers: Standard and Optional
Part Number Description
107-9037 Narrow Wiehle
107-9038 Wide Wiehle
107-9039 Full Roller
107-9036 Rear Roller
106-6945 Rear Roller
93–9045 Anti Scalp Wiehle
Use the following table and Figure 56 to set the rate of clip.
Drive pulley number of
teeth
27 (standard)
22
22
The reel is shipped with one 27 tooth and one 22 tooth pulley. To get a .16 inch clip, you must purchase a 22 tooth
pulley. The clip can only be changed on the reel drive (Figure 56). Do not change the drive ratio on the gearbox
pulleys.
Flex Greensmower Cutting Unit Set-up Matrix
Description
Description
Clip (Refer to Figure 56 for pulley locations.)
Driven pulley number
of teeth
22 (standard)
22
27
Mower Aggressiveness
Flex 21
Flex 21
Mower
Height of Cut Range
Flex 21 0.062 - 0.125 inches
Flex 21 0.125 -0.25 inches
Flex 21 0.25 inches and up
Flex 21 0.062 - 0.125 inches
Mower Diameter/Material
Flex 21 2.5 inches Aluminum
Flex 21 2.5 inches Aluminum
Flex 21 2.5 inches Steel
Flex 21 2.0 inches Aluminum
Flex 21 2.0 inches Steel
Flex 21 2.5 inches Aluminum
1–7/8 inches longer
14 Blade Clip inch (mm) 11 Blade Clip inch (mm) 8 Blade Clip inch (mm)
0.112 (2.9)
0.138 (3.5)
0.169 (4.3)
32
Less Standard
More
Standard
Less Aggressive
Comments
Standard Front
More Penetration
Least Penetration
Standard Rear
Steel Rear
More edge support
0.143 (3.6)
0.176 (4.5)
0.215 (5.5)
Comments
Comments
0.197 (5.0)
0.241 (6.1)
0.296 (7.5)