Toro 04022 Operator's Manual page 31

Figure 53
1. Rear roller bracket
2. Height-of-cut arm
2. Loosen nut on gauge bar (Figure 54) and set
adjusting screw to desired height-of-cut. Distance
between bottom of screw head and face of bar is
height-of-cut.
Figure 54
1. Gauge bar
2. Height adjusting screw
3. Hook screw head on cutting edge of bedknife and
rest rear end of bar on rear roller (Figure 55).
3. Locknut
4. Adjusting screw
3. Nut
4. Rotate adjusting screw until roller contacts front of
gauge bar. Adjust both ends of roller until entire
roller is parallel to the bedknife.
Important: When set properly, the rear and
front rollers will contact the gauge bar and the
screw will be snug against the bedknife. This
ensures that the height-of-cut is identical at both
ends of the bedknife.
5. Tighten nuts to secure adjustment. Do not
overtighten nut. Tighten enough to remove play
from washer.
Note: Use the following chart to determine which
bedknife is best suited for the desired height of cut.
31
Figure 55