Husqvarna 2-20DT Operator's Manual page 17

6. Push the ON button to start the control panel.
7. Engage the drive system. Refer to
drive system on page 11 .
8. Push the ON button to start the blastmotors.
9. Wait until the ammeters are in idle position.
2037 - 002 - 06.04.2023
10. Turn the speed control dial to set the drive speed.
To operate the product
To engage the
1. Make sure that the work area is safe. Refer to
2. Fill the abrasive separator with abrasive. Fill the
3. Start the product. Refer to
4. Engage the drive system. Refer to
5. Operate the drive system lever.
6. Pull the abrasive control lever to open the abrasive
WARNING:
rearward operation only. Do not move the
product forward during operation.
WARNING:
during operation. Abrasive comes out of the
product at high speed and can cause injury.
area safety on page 7 .
separator with abrasive when necessary. Refer to
fill the product with abrasive on page 15 .
page 16 .
drive system on page 11 .
To operate the abrasive valves on
valve. Refer to
page 13 .
This product is for
Do not lift the blasthousing
Work
To start the product on
To engage the
To
17