Tail/Brake Light; Replacing A Front Turn Signal Light Bulb - Yamaha Xenter 125 2011 Owner's Manual

PERIODIC MAINTENANCE AND ADJUSTMENT
3. Unhook the headlight bulb holder,
and then remove the burnt-out
bulb.
4. Place a new headlight bulb into
1
position, and then secure it with
the bulb holder.
5. Connect the coupler, and then in-
2
stall the headlight bulb cover.
6. Install the cowling together with
3
the headlight unit.
7. Have a Yamaha dealer adjust the
4
headlight beam if necessary.
5
6
7
8
9

Tail/brake light

1. Tail/brake light
This model is equipped with an LED-
type tail/brake light.
If the tail/brake light does not come
on, have a Yamaha dealer check it.
6-29
EAU24181
Replacing a front turn signal
light bulb
If a front turn signal light burns out, re-
place it as follows.
1
1. Remove cowling A. (See page
6-7.)
2. Remove the socket (together with
the bulb) by turning it counter-
clockwise.
1. Turn signal light bulb socket
EAU1722A
EAUT3650
1