Replacing A Front Turn Signal Light Bulb; Replacing The Tail/Brake Light Bulb Or A Rear Turn Signal Light Bulb - Yamaha XMAX 125i 2005 Owner's Manual

Replacing a front turn signal
light bulb
CAUTION:
It is advisable to have a Yamaha
dealer perform this job.
1. Place the scooter on the centers-
tand.
2. Remove cowling A. (See page
6-6.)
3. Remove the socket (together
with the bulb) by turning it coun-
terclockwise.
4. Remove the defective bulb by
pushing it in and turning it coun-
terclockwise.
PERIODIC MAINTENANCE AND MINOR REPAIR
EAUT1260 5. Insert a new bulb into the socket,
push it in, and then turn it clock-
wise until it stops.
ECA10670
6. Install the socket (together with
the bulb) by turning it clockwise.
7. Install the cowling.
Replacing the tail/brake light
bulb or a rear turn signal
light bulb
Tail/brake light bulb
1. Remove the tail/brake light bulb
2. Remove the defective bulb by
3. Insert a new bulb into the socket,
4. Install the lens by installing the
6-25
lens by removing the screws.
pushing it in and turning it coun-
terclockwise.
push it in, and then turn it clock-
wise until it stops.
screws.
EAUS1250
6