Philips ReCare 7.5 S User Manual page 18

The 7.5 S is an easy product to set up and use, from the adjustments to
the intuitive interface. This section explains how to set up, adjust and
operate your 7.5 S.
Leveling the 7.5 S
• Once the 7.5 S is assembled, and placed on a at level oor, it may
be necessary to adjust the leveling glides on the bottom of the unit
to ensure proper stability of the 7.5 S. Use a 1/2" wrench to loosen
the top nut of the levelers. Adjust the front 4 corner levelers by
hand as necessary to remove any wobble in the unit. Then tighten
all the top nuts against the bottom of the stabilizer tubes. Make
sure the bottom nut remains cinched against the leveling foot.
Connecting to A.C. power
• The 7.5 S uses a universal switching power supply. You can plug the
7.5 S power supply into any A.C. power source from 100 to 240 volts,
50 to 60 hz. The A.C. Input is located in the front of the unit.
Seat adjustments
Seat position number
line up with front edge
of the seat carriage
Adjusting the seat fore/aft position
• Squeeze the brake handle located on the left side handle bar. Move
the seat to the desired position and release the handle. Move the
seat slightly until the seat lock clicks in place. There is a numbered
scale located on the seat slide plate for repeatable settings. Seat
position is indicated by the front of the seat carriage lining up with
the number on the scale.
3 5
1
6
4
2
Seat back angle
indicator
18
Lift handle to rotate
seat. Lower handle to
activate latch.