Table of Contents
Advertisement
Assembly
Read each step's instructions and study the drawing carefully to become
familiar with all the parts and procedures before beginning each step.
Step 1. Pedals, seat latch handle and handle bar assembly
• Slide the handle bar assembly (17) onto the receiving tubes of the
seat frame. Secure the handle bar assembly starting with two 3/8" x
3-1/4" bolts (140), four 3/8" at washers (170) and two 3/8" nylon
nuts (190). NOTE: Install the safety cover (108) and seat belts (233)
onto bolts before assembling washers and nuts. Install four 3/8" x
2" bolts (132) from the top side of the tubes and secure with four
3/8" at washers (170) and 3/8" nylon nuts (190).
• Attach the end of the seat back gas shock to the seat back angle
adjustment bracket of the handle bar assembly (17) using one 5/16"
x 1-1/4" bolt (135), two 5/16" at washers (173) and 5/16" nylon nut
(193).
• Assemble swivel seat latch handle (22) to the seat assembly with
two 6mm x 40mm bolts (128), four 5/16" curved washers (185) and
two 6mm nylon nuts (187).
• Assemble the rubber isolators (82) and pedals (28) to the pedal foot
plates with six M5 Phillips screws (181) per side.
• Press the two stabilizer end caps (31) into the stabilizer tubes. May
tap in with a rubber mallet.
• Install the two wheelchair anchor assemblies (235) with the 3/8" x
5/8" bolts (216) and M10 x 30 bolts (258) into the outside holes in
the top of the frame tube and 3/8" at washers (217) and 3/8" split
washers (243) on the top of the tube and the 3/8" curved washers
(218) on the front of the tube.
• Install the seat assembly (18) with the 3/8" x 2-1/2" bolts (178) and
use the 3/8" at washers (217) and 3/8" split washers (243) on the
top of the tube and 3/8" at washers (217) and 3/8" nut (255) on the
bottom of the tube and the 3/8" x 3-3/4" bolts (206) the 3/8"
curved washers (218) on the front of the tube.
42
Advertisement
Table of Contents
