Husqvarna 1-10DPS75 Operator's Manual page 20

General product maintenance
Do a check of the control cage,
blastwheel and liners for wear.
To do before you oper-
Refer to
ate the product on page 9 .
Do a check of the drive belt ten-
sion.
Do a check of the drive chain
tension of the drive system.
Clean the drive chain of the
drive system.
Do a complete servicing and
cleaning of the product.
To clean the product
• Always clean all the equipment after use. Use a
vacuum cleaner.
• Do not use a high-pressure washer to clean the
product.
• Keep the air openings clean and clear to make
sure that the product always has sufficiently cool
temperature.
To clean the chain of the drive system
1. Remove dirt on the outer surface of the chain with a
hard brush or wire brush.
2. Clean the chain with cleaning agent.
3. Remove dirt from internal parts of the chain.
To remove and install the control cage
1. Remove the feed spout.
20
Each 3 h Daily
X
X
12 h after
service
2. Remove the cage clamps and the control cage.
3. Install the control cage in opposite sequence.
To remove and install the blastwheel
1. Remove the feed spout and the control cage. Refer
To remove and install the control cage on page
to
20 .
Each 3
Yearly
months
X
X
X
O
2014 - 001 - 07.02.2023