Fujitsu AIRSTAGE ARUX12TLAV2 Installation Manual page 6

(1) Remove the panels.
* Do not lose the grommets that protects the refrigerant pipes.
Grommets
(2) Untie the cables.
(A) Cut the cable tie (medium).
(B) Loosen the cable clamp.
(C) Remove the cable clamps and screws. 1 set will be reused in step (11).
(D) Cut the cable ties (small) that binds the cable to the piping. Binding position and the
number varies depending on the model.
ARUX12/18/24/30/36/48
(A)
(A)
(B)
(C)
(C)
(D)
(D)
En-5
ARUX60
(D)
(D)
(3) Cut the cable tie that holds the room temperature thermistor inside the heat exchanger
(access from the intake port), and remove the room temperature thermistor from the
heat exchanger.
ARUX12/18/24/30/36/48
Thermistor holder (copper tube)
(4) Remove the thermistors for gas and liquid pipes. (2 places)
* Do not lose the fixing springs.
ARUX12/18/24/30/36/48
(A)
(A)
(B)
(C)
(C)
(5) Remove the coil on the solenoid valve.
* Protect the removed thermistors, solenoid coil, and cables with curing tape, etc. so that
(D)
they will not be damaged.
ARUX12/18/24/30/36/48
(D)
Do not cut this cable tie.
Cut this cable tie.
Fixing spring
Thermistor holder
(copper tube)
Solenoid coil
ARUX60
ARUX60
Thermistor
ARUX60