Steps
1. Align the screw holes on the hard drive with the screw holes on the hard-drive bracket.
2. Replace the four screws (M3x3.5) that secure the hard-drive bracket to the hard drive.
3. Slide the hard-drive assembly into the slot on the display-assembly base.
4. Replace the screw (M3x5) that secures the hard-drive assembly to the display-assembly base.
Next steps
1. Install the
back
cover.
2. Install the stand.
3. Follow the procedure in
Solid-state drive
Removing the M.2 2230 solid-state drive
Prerequisites
1. Follow the procedure in
2. Remove the stand.
3. Remove the
back
cover.
4. Remove the
I/O
cover.
5. Remove the
system-board
About this task
NOTE:
The M.2 card installed on your computer will depend on the configuration ordered. The supported card
configurations on the M.2 card slot are:
● M.2 2230 solid-state drive
● M.2 2280 solid-state drive
NOTE:
This procedure applies only to computers shipped with an M.2 2230 solid-state drive.
After working inside your
Before working inside your
shield.
computer.
computer.
Removing and installing Customer Replaceable Units (CRUs)
57