Table of Contents
Advertisement
1. Toggle to the right to enter OSD
Menu Screen.
2. Toggle to the up or down to select
main menu [PBP], then toggle to the
right to confirm.
3. Toggle to the up or down to select
[PBP Mode], then toggle to the right.
4. Toggle to the up or down to select
[PBP], then toggle to the right to
confirm your selection.
5. Now you can move backward to set
the [PBP Input], [PBP Mode], [PBP
Input] or [Swap].
6. Toggle to the right to confirm your
selection.
MultiView in OSD menu
[PBP]: Picture by Picture
Open up a sub-window
side-by-side of other
signal sources.
When the sub source is
not detected.
Note
The black strip shows on the top and
the bottom of the screen for the correct
aspect ratio when in the PBP mode. If
you expect to see full screen side by side,
adjust your devices resolutions as pop up
attention resolution, you will able to see
2 devices source screen project to this
display side by side without black strips.
Note the analog signal is not support
this full screen in PBP mode.
A
B
(main)
A
(main)
13
[PBP Input]: There are different video
input to choose as the sub display
source: [1 HDMI 2.0], [2 HDMI 2.0],
[DisplayPort]and [USB-C].
Please refer below table for compatibility
of main/sub input source.
Inputs
1 HDMI 2.0 2 HDMI 2.0 DisplayPort
1 HDMI 2.0
MAIN SOURCE
2 HDMI 2.0
(xl)
DisplayPort
USB-C
[Swap]: The main picture source and the
sub picture source swapped on
the display.
Swap A and B source in [PBP] mode:
A
B
(main)
[Off]: Stop MultiView function.
Note
When you do the SWAP function, the
video and its audio source will swap at
the same time.
SUB SOURCE POSSIBILITY (xl)
●
●
●
●
●
●
●
●
●
●
●
●
B
↔
(main)
A
(main)
USB-C
●
●
●
●
A
Advertisement
Table of Contents
