Network Communication Interfaces - Dell N03G Installation And Operation Manual

Got to line number 42 and change the first console-ttyS0 so that it points to ttyS6 console=ttyS6. Now the line in the
file should look like this:
42 set cmdline="root=LABEL=$label ro init=/lib/systemd/systemd console=ttyS6
console=tty1 panic=-1"
Save the file, and reboot the Edge Gateway. Upon reboot you will be able to see the Operating System boot process as
well as you will be able to login to the gateway via the console screen that is using the serial port on the front of the
Edge Gateway.

Network Communication Interfaces

The Edge Gateway 3000 series comes with two Ethernet connections, one 802.11b/g/n wireless network connection, and
one Bluetooth network connection.
Ethernet (Port 1, eth0)
Assuming that you have an internet enabled Ethernet cable plugged into Port1, your screen should be similar to the one
below after running the ifconfig command. If the Wi-Fi and Bluetooth have not been configured you will not see
them present in the network device list.
(plano)ubuntu@localhost:~$ ifconfig
After running the ifconfig command:
eth0 Link encap:Ethernet HWaddr 74:e6:e2:e3:0f:12
inet addr:192.168.28.216 Bcast:192.168.28.255
inet6 addr: fe80::76e6:e2ff:fee3:f12/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:11 errors:0 dropped:0 overruns:0 frame:0
TX packets:19 errors:0 dropped:0 overruns:0 carrier:0
Collisions:0 txqueuelen:1000
RX bytes:1740 (1.7 KB) TX bytes:2004 (3.0 KB)
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:65536 Metric:1
RX packets:160 errors:0 dropped:0 overruns:0 frame:0
TX packets:160 errors:0 dropped:0 overruns:0 carrier:0
Collisions:0 txqueuelen:1000
RX bytes:13920 (13.9 KB) TX bytes:13920 (13.9 KB)
(plano)ubuntu@localhost:~$
Wi-fi (mlan0)
You will use the Network Manager TUI graphical manager to add/remove wireless networks which can be found in the /
apps/bin folder.
(plano)ubuntu@localhost:~$ cd /apps/bin
(plano)ubuntu@localhost:~$ cd /apps/bin
(plano)ubuntu@localhost:/apps/bin$
(plano)ubuntu@localhost:/apps/bin$ sudo ./nmtui
After you add a new Wi-Fi connection, return to the command prompt and run the ifconfig command again. You
should see that your Wi-Fi network device has connected to the access point you just added and it has obtained an ip-
address.
Bluetooth
Use the supplied command line utility to add/remove/communicate with Bluetooth devices. The command line utility can
be found in the /apps/bin folder.
Before setting up the Bluetooth connection, a Bluetooth device that is discoverable and can discover other devices (for
example a cell phone)– is called device_2.
Mask:255.255.255.0
49