Additional Communication Interfaces - Dell N03G Installation And Operation Manual

Default provided configuration is:
interface=uap0
driver=nl80211
ssid=Ubuntu
hw_mode=g
channel=6
macaddr_acl=0
auth_algs=1
ignore_broadcast_ssid=0
wmm_enabled=1
ieee80211n=1
WPAPSK
Example:
interface=uap0
driver=nl80211
ssid=Ubuntu
hw_mode=g
channel=6
macaddr_acl=0
auth_algs=1
ignore_broadcast_ssid=0
wpa=2
wpa_passphrase=UbuntuAP
wpa_key_mgmt=WPAPSK
wpa_pairwise=TKIP
rsn_pairwise=CCMP
wmm_enabled=1
ieee80211n=1
To reload configuration and restart the hotspot, run the $ sudo snap service restart swaccesspoint
command.
In the case of a network being manually configured via ifupdown, the software access point will not start as it would
otherwise clash in the wireless namespace. The same is not true of Network Manager configured networks, those don't
cause the AP to stop and depending on the setup can work at the same time.
In case of any issues, please bring down the mlan0 connections setup by Network Manager and allow configuration
through the provide web interface.
Modes of operation - Client Network Selection
The second mode of operation is that of using the AP to leverage a default interface for finding and connecting to other
local wireless networks. This is the use case of an out-of-the-box experience where the AP is solely being used for
initial configuration.
If you connect a client to the access point and point the browser to http://10.0.60.1:8888 you can find a web interface.
Through this web interface, you can scan for nearby networks of the device and configure its connection to an SSID of
your choice. By doing this the access point functionality is disabled and the device goes into client/managed mode.
Upon selection of a network and introduction of the password, the device will configure the network and reboot. Note
that the client device on which the browser was running should now join the same network to connect to Snappy
Ubuntu Core Series 16 system.

Additional Communication Interfaces

CANbus
The device used in the Edge Gateway 3000 is the Microchip PIC32MX530F128H microcontroller. This feature is only
supported if hardware module presented, OS provides the capability of mutual communication between user space
application and physical module. If there is a specific CAN bus programming requirement of user mode application,
contact the hardware provider of that module for API documentation.
The CANbus LEDs default state is OFF, and will only be ON when data is being transmitted.
Ready to use software to control or manipulate the device is not available from Dell. The information listed below is
provide by the device's manufacturer. Dell does not have any specifications regarding the function of F/W design of
51